Fill Dirt delivery in Shreveport, LA

Fill-dirt is often cheaper per ton than clean gravel in Shreveport because it is mostly soil and fines rather than quarried stone. Prices vary by supplier and availability, and regional factors like local clay deposits can affect cost. Remember Hello Gravel has a 3-ton minimum and delivery fees vary, so get a local quote to compare total cost.

Covering fill-dirt with gravel can reduce surface erosion, but it is not a complete solution for heavy rainfall common around Shreveport. For best results use a geotextile fabric between the fill and gravel, proper edge restraint, and slope grading to direct runoff. Compaction of the fill-dirt and vegetation or erosion-control measures may also be needed.

Fill-dirt is not ideal where drainage is important because it tends to hold water, especially the local clay-rich soils in the Shreveport area. For drainage you should use clean, free-draining material such as 3/4-inch crushed stone or drain rock and include perforated pipe if needed. Use fill-dirt only as structural backfill where drainage is not critical and ensure proper compaction.

You can use fill-dirt for non-structural backfill, but near foundations or retaining walls it is better to use engineered or free-draining backfill per your engineer or local code. Shreveport's clay soils can expand and retain moisture, so projects that affect a structure usually require specified backfill, compaction in lifts, and sometimes a drainage layer. Contact your contractor or Hello Gravel for material recommendations for your site.

For light grading or top dressing, you can spread fill-dirt over an area, but you should remove vegetation and organic topsoil where you need a stable subgrade. In Shreveport, soft or clayey spots will often need some excavation or stabilization before adding fill-dirt to avoid future sinking. Plan for compaction and order 10-15% extra to allow for settling and compaction.

Calculate volume by area times depth: for 1,000 sq ft a 2-inch depth equals about 6.2 cubic yards, and a 4-inch depth equals about 12.3 cubic yards. Fill-dirt typically weighs about 1.1 to 1.3 tons per cubic yard, so 2 inches would be roughly 7 to 8 tons and 4 inches roughly 14 to 16 tons. Always order 10-15% extra to account for compaction and uneven spreading.

Quantity depends on the driveway width and desired depth; for example a 20 ft by 10 ft driveway at 3 inches deep needs about 1.85 cubic yards (roughly 2 to 3 tons), which is below Hello Gravel's 3-ton minimum. Hello Gravel delivers by dump truck with standard delivery in 2+ business days and a next-day option if ordered before noon CST for an additional fee. Use our online calculator or request a quote to get an exact amount and delivery price for your address in Shreveport.

The 70/30 rule (70% topsoil to 30% compost) refers to planting mixes and does not apply to fill-dirt because fill-dirt is not topsoil and lacks organic matter. In Shreveport, use good topsoil or amend it with compost for planting beds, and reserve fill-dirt for raising grades or structural fills below the planting layer. If you must place fill-dirt, cover it with at least 4-6 inches of quality topsoil before planting.

Fill-dirt is mainly soil and fines chosen for compaction and bulk raising of grades, while 2A, 2B, and similar gravels are crushed stone mixes intended for structural base, drainage, and stabilization. In Shreveport projects that need drainage, load-bearing capacity, or a stable driveway base should use specified gravels rather than fill-dirt. Use fill-dirt where compaction and volume are the priority and gravel where strength and drainage matter.

No, filling a hole with fill-dirt will not improve drainage because fill-dirt holds water; it may make the problem worse in Shreveport's clay soils. For drainage, backfill trenches with clean rock or gravel and install perforated drainage pipe as required. Consult a drainage contractor for solutions tailored to local soil and rainfall patterns.

Fill-dirt compacts and becomes firmer over time, but it does not harden like concrete nor provide the same bearing performance as compacted crushed stone. For traffic areas, driveways or base layers in Shreveport, use crushed stone or engineered base materials and geotextile stabilization instead of relying on fill-dirt alone. Fill-dirt is best used to raise grade and then capped with suitable surface material.

Two inches of fill-dirt can work for light top-dressing to correct minor grade issues, but it is not enough for structural fills, building pads, or to cover poorly compacted subgrade—those applications typically need several inches to feet and staged compaction. In Shreveport, because of clay soils and potential settling, plan deeper lifts with compaction or consult a contractor for recommended depths. Always account for compaction and order extra material.

Backfilling costs include material, delivery, spreading, and compaction; when using fill-dirt in Shreveport you'll also factor in extra compaction or import of engineered fill if local clay is unsuitable. Hello Gravel can provide material and delivery with a 3-ton minimum and transparent pricing, but labor and compaction services are typically billed separately by contractors. For an accurate total, get a written quote that lists material, delivery, and any compaction or hauling fees.